Miata Exhaust System:
Header- We have tested many headers and have settled on these stainless headers from Japan. They have a nice cast flange that mates up with the ports in the head very nice. We add a flex joint to further reduce the chances of stress cracking. Then finish if off with a convenient 3/8" flange.
1600 = $350
1800 = $400
Muffler- We use a 2-1/2" Straight thru muffler that has been located in the proper place in the exhaust by many hours of dyno time. $75.00
Mid Pipe- Made of 2-1/2" Aluminized steel with mandrel bends, we spent a lot of time fine tuning the bends to provide maximum clearance for the inboard axle flange. $75.00
Exit Pipe- We made this a separate piece for several reasons. Number one was so we could easily ship the exhaust system. Number two is so we could offer an additional muffler in its place for those who need to meet more strict noise regulations. $32.50
2-1/2" Band Clamp- $21.00
Engine to Tail Pipe
1600 = $500
1800 = $550
if you purchase as a kit.
We can modify your header with a flex and flange to fit our rear tailpipe for $100.
